Cleaning the Printhead Open the Front cover and back cover. Number of stop bits 1 or 2 Turn over the head assembly. Adjusting the Printhead Pressure Screws decrease pressure increase pressure When opening the front cover, you can see two screws on the top of the printhead assembly. Setting Up Your Printer 2. To print the manual completely, please, download it.

Uploader: Galkree
Date Added: 9 September 2009
File Size: 8.41 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29121
Price: Free* [*Free Regsitration Required]

Open the front cover and back cover. Load large label roll Open the front and back cover. Number of stop bits 1 or 2 Cutter We suggest that the minimum label height be more than 35 mm.

Godex EZ-4TT Manuals

The paper jam may cause the cutter work improperly, power off the printer. Remove the label roll stands part This manual also for: Refer described on page 5. Goddex Test Release the feed button after the printer beeps 3 times.

Loading Label Roll Fig. Setting up Your Printer Number of data bits 7 or 8 p4: Press the printer lock part 14 to loosen the printhead assembly.


Whatever media in used, the recommended minimum label height is 20 mm. Ea case of non heat-sensitive paper, a suitable thermal transfer ribbon must be used.

Don’t show me this message again. To print the manual completely, please, download it.


Comments to this Manuals Your Name. Maintenance and Adjustments Disable the Self-test, please power off the printer at least 2 seconds, than power on again.

Table of Contents Add to my manuals Add. Setting Up Your Printer 2. Enter text from picture: Perform a Label Gap Godx Adjustment as described on page Put back the printhead and fasten it.

Godex EZ-4TT Manuals

The strip bracket bar is used for strip function. Press the printer locks part 12 to loosen the printhead assembly, and turn over the head assembly. Vertically place the two stands along the left side and right side of the back cover see Fig.


Contents The contents comprise of the following: Use a soft cloth soaked with isopropyl alcohol to remove the stuck label and cleans the surface. Maintenance And Adjustments 3.

Seagull Godex EZ-4TT Free Driver Download (Official)

Only when the separated label has been taken away, will another label be printed automatically. With different paper material or ribbon material, you may need to adjust the printhead pressure by turning these two screws to decrease or increase the pressure. Stripper Stripper Peeler helps you separate the printed godes from the liner backing paper.

If you need any help in installation and maintenance, please consult your supplier or dealer.