D COPIA 163MF DRIVER

Remove the outer covers See P. Cleaning cloth Suitable for laser printers. Page 38 This page is intentionally left blank. The developing roller contains a 3-pole S-N- S magnet core and an aluminum cylinder rotating around the magnet core. No primary paper feed.

Uploader: Yosida
Date Added: 7 September 2012
File Size: 35.86 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20445
Price: Free* [*Free Regsitration Required]

System Settings System Settings The machine is equipped with a system settings which can be operated by users mainly by 1633mf machine administrator. Install the toner container in the printer. Page 20 Unlocking the shipping lock.

Drivers for OLIVETTI d-Copia MF Printer

Zoom key Combine key and indicator User Interface Operation Toner container Toner container release lever Figure 8. Optical Module Unit Remove the language label sheet. Remove the outer covers See P. Open the front cover.

Olivetti d-Copia 163MF

Press key to coipa the item. Maintenance And Error Messages Low Power Mode Press the key to select the language to be 1.

  A525 SPEAKERS DRIVER

Open the DP cover. Scanner belt Bottom view Scanner belt Optical module unit Initializing the machine and printing a report page for test.

Toner Container Replacement The heat roller has a heater lamp W inside which continuously turns on and off by the fuser thermistor to maintain the constant temperature 1663mf the heat roller surface. Remove the two pivot pins. Pulse type Description Adjusts the ratio of make-to-break ratio of make in pulse cycles of dial pulses.

Contaminated main charger wire. Mfp Button Setting Section The toner-full sensor has detected that Defective waste the waste toner is full before the total toner full sensor. Page 26 Initializing the machine and printing a report page for test.

If none, replace the feed does not operate. Turn power switch on.

OLIVETTI d-Copia 163MF Printer Drivers

Remove the one connector. Remove the one connector from main motor. Connecting The Power Cord Remove the adhesive tape.

Power cord Top pad L Page 70 – Fuser unit Page 71 Page 72 – Detaching and refitting the heater lamp, Check or replace the optical module unit and refit all the removed parts. Executing A System Setting Item